ERYONESilk Tri-Color Coextrusion PLA Filament,3D Printer 1.75mm,+/-0.03mm, Triple Color Filament 1KG(2.2lbs), Silk Red,Blue and Green

Se ve muy bien las impresiones con el color

This filament is incredible. Smooth and crisp prints. Its too bad the infill has to be hidden cuz the colors really shine.

Love the colors - Red, Blue, and Green! Even though I am color-blind this filament puts out some nice 3D printed creations. I like the feel, design ability, and creativity allowed when using this Tri-color. I've had a lot fewer errors and misprints with this brand of filament than others, and the silk has a great finished feel.

So, the filament is gorgeous overall. It has a nice bright, reflective color. It has good adhesion. No issues with it sticking to the bed or itself. Surface of print was flawless with little to no stringing, pimples, blemishes, etc. The issue it has is that it has...bands, for lack of a better word. Normally bi and tricolor filament will be different colors depending on the angle and side of the print you are looking at and it'll be more or less consistent on the z axis. With this it shifts in bands. It'll be yellow for a while, then blue, then back to yellow, then blue, then red then yellow, etc. I tried changing a bunch of settings, using different slicers and then I tried a different brand of tri-color filament and...no banding. Best I can come up with is that the filament itself must have twists in it periodically that change which color extrudes in which direction. All considered it's a relatively minor issue with an otherwise flawless (in my opinion) filament and perfectly fine if that is the effect you are going for. I was trying for a consistent rainbow effect to match previous prints though and this necessitated a large amount of troubleshooting and ultimately the purchase of a different roll of filament. Ordinarily I wouldn't review like this and would contact the seller for a replacement but honestly, there's nothing really WRONG with the filament other than the color doesn't come out the way I expected and at this point I've printed MOST of the spool trying to figure out what was the issue so, y'know. Be aware the color is wonky but otherwise this stuff is great.TL:DR Prints great, color is inconsistent. See photo.

Unless your printer is dialed in for Silk PLA, this filament is one of the trickery ones to get to print as expected. I feel that the settings recommended on this filament are incorrect, whenever I attempted to go by the guidelines most of my prints failed.I'd say a better temp is 210 with a print speed of 200, but your mileage may vary.Your printer also needs to be dialed in well, especially the leveling. For me, I needed to ensure the "A4 Paper" test was slightly rough to pull against my PEI bed and the extruder (but not so tight as to be unable to push or pull the paper). Once that's configured, I find myself printing nice quality prints with this filament.